Veea's IoT (Internet of Things) Device Manager application enables users to manage their radio devices (LoRaWAN, Bluetooth, and Zigbee) and Data Broker remotely. It is a single point where users can manage and configure all the IoT devices connected to their VeeaHubs and meshes.
About these articles
These articles show you how to use Veea’s IoT Device Manager Application to remotely manage and control your sensors and devices. IoT Device Manager is comprised of four managers, which are described in separate pages:
Accessing Veea IoT Device Application Manager
The connection to the IoT Device Application Manager dashboard is normally made through the VeeaHub default AP or LAN ports.
Access is case dependent on the vMesh mode of operation and each case is described in the procedure (steps 1 to 3) which follow:
Access Veea IoT Device Procedure
- Select the access case that applies to your vMesh installation:
-
Routed Mode (Default Access) - See Routed Mode (Default Access)
-
Routed Mode (Ethernet WAN IP) - See Routed Mode (Ethernet WAN IP)
-
Bridged Mode - See Bridged Mode
-
Routed Mode (Default Access)
- Identify the host mesh node IP address. This will be the default IP address 10.100.1.1 or if the VeeaHub has detected a conflict with that, it will be 172.20.1.1:
- In the browser address bar, enter the IP address and port number (http://<host IP>: 9071), for example: http://10.100.1.1:9071/
Routed Mode (Ethernet WAN IP)
- See the WAN IP in VHM or Node Manager.
- In the browser address bar, enter the IP address and port number (http://<host IP>: 9071), for example: http://192.168.0.34:9071/
Bridged Mode
- See the WAN IP in VHM or Node Manager.
- In the browser address bar, enter the IP address and port number (http://<host IP>: 9071), for example: http://10.100.1.1:9071/
- In the IoT Device Manager sign in dialogue:
- Enter the email address(ii)
- Enter the Password(ii).
(ii)Note. Request IoT Device Manager sign in credentials from Veea Customer Support
- Click the Sign in button.